Manual Omnivore Grinder Pump, 25' cord, 2 HP, 208/230V, 3-Phase

Description

Overview:
Liberty Pumps LSG203M
is a 2HP 208-230V Manual Submersible Grinder Pump (3 Phase) with 25ft quick-disconnect power cord.
Liberty's LSG200-Series Omnivore grinder pumps meet the demanding needs of commercial and residential sewage applications where difficult solids-handling ability is crucial.
Superior cutting system of the Liberty Grinder Pumps LSG203M provides improved shredding performance over radial cutters. V-pattern provides up to 108 alternated cuts per revolution. The entire cutting system made of 440 stainless steel hardened to 58Rc. Recessed cutter bolt eliminates wadding Exclusion cleanout slots and back relief clears debris from undercutter.
Liberty LSG-Series Grinder Pumps are designed for continuous underwater operation. The motor and pump form a close coupled, watertight unit. The induction motor is insulated against heat and moisture in accordance with Class B 265F regulations.
The Omnivore Grinders may be guided rail mounted using Liberty's GR20 guide rail base, or stand-alone.
Liberty Pumps G90 Flanged Elbow provides vertical discharge for non-guide rail installations.
The Liberty LSG203M Grinder Pump features internal capacitors and does not require a separate control panel for operation.
NOTE: Requires a separate approved pump control device or panel for automatic operation. Operation of these models will be according to the control selected. Make sure the electrical specifications of the control selected properly match the electrical specifications of the pump. Always refer to control panel instructions for proper installation.
3-phase models require a properly sized control panel. Check three phase pumps for proper rotation prior to installing pump(s) in basin.
Features:
2HP, heavy-duty motor - oil filled
Advanced V-Slice cutting system made of hardened 440 stainless steel - Rockwell C 58
Internal capacitor
Upper and lower ball bearings
One-piece uni-body cast iron housing
300 Series SS Rotor Shaft
316 Stainless steel impeller
Dual seals - Upper seal is unitized durable silicon carbide. Lower seal is Viton double-lip. (Lower seal ensures that all debris is kept away from main seal)
Motor windings insulated to Class B (265°F)
New Patented V-Slice cutter technology
Horizontal 1-1/4" FNPT Discharge
Back vanes on impeller and spiraled bottom plate for superior solids clearing
All stainless steel fasteners
Clog-free volute design
Designed for maximum heat dissipation and cool motor operating temperatures
Solid state starting circuit - no mechanical relay coil
25' power cord with Quick-Disconnect
Technical Specifications:
Horsepower: 2HP
Shut-off Head: 108'
Voltage: 208-230V
Phase: 3
Speed: 3450 RPM
Motor service factor: 1.0
Full load ampers: 10.6
Locked rotor ampers: 62
Starting circuit: N/A
Maximum fluid temperature (Intermittent): 140°F
Maximum fluid temperature (Continuous): 104°F
Thermally Protected: No
Stator winding class: B
Cord length: 25'
Discharge: 1-1/4" NPT Flanged
Weight: 86 lbs.