Dayton Sump Pump 3BB75, Submersible Sump Pump, 3/4 HP, Cast Iron,120V AC No Swit

Description

Dayton Sump Pump 3BB75, Submersible Sump Pump, 3/4 HP, Cast Iron,120V AC No Switch.
New never been used, no original box, instruction or any hardware, just pump. Pump does show some scuffs & or scratches. Also has some light surface rust.  I have tested this and it works. There is also a crack on the handle.
Approx. ship weight 45Lbs
PLEASE SEE
ALL
PHOTOS AS THEY ARE PART OF THE DESCRIPTION!  What you see in the photo is what you will be getting. Please be sure to read all descriptions on label.
INTERNATIONAL BUYERS!!!
THESE WILL NOT BE SHIPPED INTERNATIONALLY.WILL NOT SHIP TO ALASKA, HAWAII & PUERTO RICO
I charge a 20% restocking fee for items returned due to customer error or non-warranty related returns. Shipping will not be refunded unless the item was received DOA or item was not as described.
T
hese 110V submersible sump pumps have a cast-iron body that helps dissipate heat as the pump drains water from sump pits. They are compatible with most standard U.S. residential electrical wall outlets and have a Type A (two prongs, ungrounded) or Type B (three prongs, grounded) power cord plug. Pumps have a painted or powder-coated finish to protect the body from corrosion.
Submersible sump pumps drain water from basement sump pits and operate while completely underwater at the bottom of the sump pit. They are submerged in the water to cool the pump motors so they can run longer without overheating, compared to upright/pedestal sump pumps that have motors above the sump pit. Submersible pumps are electric-operated and have a pump body and pump motor combined into one unit. They have a switch that starts the pump motor when sump pit water rises to a certain height, then stops the pump motor when the water has drained down.
Item
Submersible Sump Pump
HP
3/4
Rated Voltage
120V AC
Hz
60 Hz
Amps
10.5 A
Switch Actuation
No Switch Included
Switch Electrical Connection
No Switch Included
Body Material
Cast Iron
Impeller Material
Cast Iron
Shaft Seal Material - Pumps
Carbon Ceramic
Flow Rate @ 5 Ft. of Head
113.0 gpm
Flow Rate @ 10 Ft. of Head
101.0 gpm
Flow Rate @ 15 Ft. of Head
92.0 gpm
Flow Rate @ 20 Ft. of Head
80.0 gpm
Max. Head
37.0 ft
Body Dia.
10 in
Overall Height
13 in
Discharge
1-1/2 in FNPT
Max. Diameter Solids
1/2 in
Max. Liquid Temp.
104 Degrees F
Duty Cycle
Continuous
Cord Length
15 ft
NEC Cord Designation
SJTOW
Gauge/Conductor
16/3
Alarm Included
No
Base Material
Cast Iron