DAYTON Sewage Ejector Pump, HP 4/10, Flow Rate @ 10 Ft. of Head 95.0 gpm, 4HU79

Description

These general purpose 110 to 120V sewage ejector pumps remove sewage containing solids from drains where a gravity system won't work, such as in septic systems that are below the main sewer line. They are compatible with most standard U.S. residential electrical wall outlets and have a Type A (two prongs, ungrounded) or Type B (three prongs, grounded) power cord plug.
Sewage ejector pumps remove sewage containing solids from drains where a gravity system won't work, such as in septic systems that are below the main sewer line. They have no screen on the bottom of the pump and a large outlet at the top to allow debris to flow through freely. These sewage pump systems mount in a basin where waste collects from a drain pipe and they're turned on and off by an attached switch or control panel. The wastewater is then pumped out of the basin and up to the main sewer or septic line
Item
...
Sewage Ejector Pump
HP
...
4/10
Rated Voltage
...
120V AC
Phase ...
1
Amps...
12.00
Motor Type
...
Hermetically Sealed/Oil Filled
Body Material
...
Cast Iron
Impeller Material
...
Cast Iron
Shaft Seal Material...
Carbon Ceramic
Switch Actuation...
No Switch Included
Switch Electrical Connection
...
No Switch Included
Flow Rate @ 10 Ft. of Head...
95.0 gpm
Flow Rate @ 15 Ft. of Head
...
70.0 gpm
Flow Rate @ 20 Ft. of Head
...
37.0 gpm
Max. Diameter Solids...
2 in
Body Dia.
...
10 3/4 in
Overall Height
...
16 3/4 in
Cord Length
...
20 ft
Discharge
...
2 in NPT
Max. Liquid Temp....
104 Degrees F
Max. Head
...
25.0 ft
Thermal Protection
...
Yes
RPM
...
1,750 RPM
Agency Compliance...
CSA
Nominal Voltage
...
110V AC