DAYTON Sewage Ejector Pump, HP 1/2 3BB88

Description

These general purpose 110 to 120V sewage ejector pumps remove sewage containing solids from drains where a gravity system won't work, such as in septic systems that are below the main sewer line. They are compatible with most standard U.S. residential electrical wall outlets and have a Type A (two prongs, ungrounded) or Type B (three prongs, grounded) power cord plug.
Sewage ejector pumps remove sewage containing solids from drains where a gravity system won't work, such as in septic systems that are below the main sewer line. They have no screen on the bottom of the pump and a large outlet at the top to allow debris to flow through freely. These sewage pump systems mount in a basin where waste collects from a drain pipe and they're turned on and off by an attached switch or control panel. The wastewater is then pumped out of the basin and up to the main sewer or septic line.
Technical Specs
Item
Sewage Ejector Pump
HP
1/2
Rated Voltage
120V AC
Phase - Pumps
1
Amps
12
Body Material
Cast Iron
Impeller Material
Cast Iron
Shaft Seal Material - Pumps
Carbon Ceramic
Switch Actuation
Tether Float
Switch Electrical Connection
Piggyback
Flow Rate @ 10 Ft. of Head
111 gpm
Flow Rate @ 15 Ft. of Head
85 gpm
Flow Rate @ 20 Ft. of Head
43 gpm
Max. Diameter Solids
2 in
Body Dia.
10 3/4 in
Overall Height
15 3/16 in
Cord Length
20 ft
Discharge
2 in NPT
Max. Liquid Temp.
104 Degrees F
Max. Head
25 ft
RPM
1,750 RPM
Nominal Voltage
110V AC